It is getting close, guys and gals. I have my tables, do you? There
are still a few left, but they may not be in the main pavilion - if
you snooze, you lose.
On a related note, Phil Bolyn has graciously offered to supply
discounted SSTRAN AMT-3000 kits (SMT Chip installed) again discounted
to this show. Last year, he supplied ten kits all of which were gone
by the end of the first day. If you would like to reserve one *and you
will be at the show*, please let me know. For the record, I take no
cut or mark-up.
I will also be demonstrating making the base loading coil as before. I
have enough wire at this point for three (3) coils, and the bag of
parts required. Note that in these troubled times, fittings have gone
through the roof. So, if you want to make a coil, please let me know
in advance so I can get the requisite number of fittings. Costs last
year (September) ran just under $40 for the basic fittings.
I may also try and demonstrate the in-line coil as was noted
previously in this venue. Those fittings might be less in cost.
See you then.
Peter Wieck
Melrose Park, PA
|
